Ricoh D093 Service Manual page 224

Development
8. Add one (1 kg) pack of developer. Do not add the second pack at this time.
Open the first developer pack [E].
Save the top of the pack. You will need the number to enter the lot number with
SP2801.
Slowly add the first pack of developer to the development unit. Move the pack from left
to right until it is empty.
Make sure that the developer is applied equally across the slot of the development unit.
9. Close the toner hopper cover [F].
10. Close the upper unit [G].
11. Connect the power supply cord.
12. Switch the main power switch on.
If the development motor starts, wait 50 sec. for it to stop. Go to Step 16.
-or-
If the development motor does not start, go to the next step.
13. Open SP2924-1. Change the "1" setting to "3".
14. Switch the main power switch off/on. The development motor starts. Wait 50 sec. for it to go
off.
15. Open SP2924-1. Change the "3" setting to "1".
16. Switch the main power switch off.
17. Open the upper unit.
18. Open the toner hopper cover.
19. Open the second 1 kg pack of developer and slowly add it to the development unit. Move
the pack from left to right until it is empty.
D093/D094 5-42 SM