Common Procedures
5.1.6 REMOVING THE ORIGINAL FEED UNIT
1.
Remove:
Left upper cover (
Right upper cover (
2.
Unlock the original unit and raise it. (
3.
Remove the plate [A] and disconnect the ground wire
4.
On the right side, disconnect the ground wires
5.
Disconnect the connectors [B] (
6.
On the ends of the original unit shaft, move the Teflon arms [C] and [D] out of the holes and
lift them until they are horizontal.
7.
Hold the Teflon arms up. At the same time, lower the original feed unit in your direction.
When it is approximately 70° from the vertical, lift it off the top of the machine.
8.
Be sure to remove the Teflon arms from the ends of the shaft so they do not fall off.
D093/D094
p.5-2 "Side Covers")
p.5-2 "Side Covers")
p.5-5 "Unlocking, Opening the Original Unit")
x 2).
5-6
(
x 1).
,
(
x 2).
SM