Enabling The Onboard Features; Using Sd Cards; Removing The Sd Card Slot Cover; Restrictions And Precautions On The Use Of Sd Cards - Ricoh D093 Service Manual

3.9.2 ENABLING THE ONBOARD FEATURES

The network and USB support features are built into the GW controller board. However, these
features cannot be used until they have been enabled with SP5985 (Device Setting). Before
installing any other options in this section, do SP5985 and make sure each item is set to "1".
SP5985-001. Must be set to "1" to enable the network functions.
SP5985-002. Must be set to "1" to enable the USB function.

3.9.3 USING SD CARDS

Removing the SD Card Slot Cover

The SD card slot cover [1] is fastened by one screw. Remove this cover to insert SD cards.
Always reattach this cover after removing or inserting SD Cards.

Restrictions and Precautions on the Use of SD Cards

Always touch a grounded surface to discharge static electricity from your hands before you
handle SD cards.
When an application is moved from one SD card to another SD card, the authentication
data is moved with the application program to the target SD card.
Do not use an SD card if it has been used with a computer or other device. (The SD card
may not operate correctly.)
The original SD card received with purchase of the application program is the only
evidence that the customer is licensed to use the application. For this reason, the original
SD card should be stored at the work site as proof of purchase by the customer. Also, the
service technician may occasionally need to check the dates and version numbers SD
cards during troubleshooting.
After an SD card has been used to combine applications on one card, it cannot be used for
any other purpose.
Always make sure that the write-protect switch is OFF before uploading data to an SD card.
SM 3-73
Installation of MFP Options
D093/D094