Service (Controller Service Modes); Bit Switch Settings - Ricoh G092 Service Manual

Bit Switch Settings

NOTE: These bit switches are all for use in Japan only.
How to Change Bit Switch Settings
1. Select "1. Service".
NOTE: "ver V.x.xx." indicates the machine's
firmware version.
2. Press the Enter key 2 times.
3. Press the up arrow key or down arrow key to
display bit switches 1 through 4.
4. Press the Enter key.
5. Press the up arrow key or down arrow key to
select a column.
6. Press the Enter key. The current value
appears in the column.
7. Press the up arrow key or down arrow key to
change the value.
8. Press the Enter key. The changed value is
stored.
9. Press the escape key 3 times.
10. Select "3. End."
11. Power the printer off, and after several
seconds, power back on, in order to activate
settings.
SM
PRINTER CONTROLLER SERVICE MODE
SYSTEMver V.X.xx
1.Service
SP1001-001
Bit Switch 1
SP1001-004
Bit Switch 4
Sw#4
bit0
Sw#4
bit3
Sw#4
bit3
Sw#4
bit3
Sw#4
bit3
SYSTEMver V.0.24
1.Service
SYSTEMver V.X.xx
3.End
5-5
G081S501.WMF
G081S502.WMF
G081S503.WMF
00000000
_
G081S504.WMF
00000000
_
G081S505.WMF
00000000
0
G081S506.WMF
00000000
1
G081S507.WMF
00001000
_
G081S508.WMF
G081S509.WMF
G081/G092