Table of Contents
Advertisement
12 July '86
28. Pre-quenching Corona Wire Replacement
1.
Remove the drum cover (2 screws).
2.
Disconnect the high voltage cable [A] from the terminal.
3.
Remove the pre-quenching corona unit [B].
4.
Remove the front and rear endblock covers [C] (1 screw on the rear
Be careful not to break off the side hooks.
cover).
5.
Unhook the spring [D] and remove the old corona wire [E].
6.
Clean the front and rear endblocks and the corona casing.
7.
Hook the large eyelet [F] of the new corona wire to the rear anchor
post.
8.
Hook the tension spring to the small eyelet [G], then hook the spring to
the front terminal.
3-42
Advertisement
Chapters
Table of Contents
