Transport Unit Removal - Ricoh FT7060 Field Service Manual

12 July '86

2. Transport Unit Removal

1. Remove the upper distribution unit.
2. Remove the following parts:
a) Manual feed table [A] (2 screws)
b) Front door safety switch bracket [B] (3 screws and 4 connectors)
c) Top cover support bracket [C] (2 screws)
d) Timing belt
CAUTION: Make sure the
as shown. If they are not installed correctly, the sorter main board
be
5. Remove the transport unit [E] (5 screws, 1 ground screw, and 6 con-
nectors).
NOTE: After disconnecting the two connectors from the power supply, pass the con-
nectors inside the side frame brace as shown.
6. Reassemble.
320XL [D]
4
connectors for the front door safety switch are installed
damaged.
6-10
will