12 July '86
6. Inverter Entrance and Inverter Registration Sensor Replacement
1.
Remove the transport unit covers.
Removal.")
2.
Remove the inverter lower exit guide [A] (2 screws).
3.
Remove the bushing securing the inverter gate pawls [B] and lower
them.
4.
Lower the front end of the guide unit [C] (2 screws).
5.
Remove the inverter entrance guide [D] (3 screws) and replace the
inverter entrance sensor [E] (1 screw and 1 connector).
6.
Replace the inverter registration sensor [F] (2 long screws and 1
connector).
Note: Check that the position of the inverter guide spring [G] is correct.
(Refer to "Transport Unit Cover
5-12