Charge Corona Wire Replacement - Ricoh FT7060 Field Service Manual

5. Charge Corona Wire Replacement

1. Remove the drum cover and take out
tor).
2. Remove the rear endblock cover [A].
side hooks).
3. Remove the front endblock cover [B] (1 screw) and the corona wires
[C]
4. Hook the small eyelets of the new wires to the tension springs [D].
5. Hook the large eyelets of the new wires to the anchor hook [E] on the
front endblock cover.
6. Set the wires in the grooves on the front endblock as shown [F], and
install the front endblock cover.
7.
Set the wires in the grooves on the rear endblock as shown [G], and in
stall the rear endblock cover.
8. Ensure that the corona wires are between the cleaner pads as shown
[H]
9.
Reassemble; then, check the wire cleaner movement using SP 5-3.
the charge corona unit (1 connec-
(Be careful not to break off the
3-5
12 July '86