Original Skew Adjustment - Ricoh FT7060 Field Service Manual

12 July '86

11. Original Skew Adjustment

1. Set the original application switch in the thin position.
2. Open the DF main board plate (2 screws), and set DPS 102 as follows:
DPS 102: l = OFF 2 = ON 3 = OFF 4 = OFF
(Free Run for Original Registration)
3. Insert an A3/11" x 17" original in the feed-in unit, and press SW101 on
the DF main board to feed the original.
4. Slowly open the DF transport unit, and check that the original is not
skewed.
5. If the rear side of the original is skewed ahead of the front side,
remove the DF front cover (2 screws), and turn the original skew
adjusting skew [A] counterclockwise. If the front side is more advanced
turn the screw clockwise.
NOTE: This adjusts the pressure between the two relay rollers.
5-18