12 July '86
20. Transport Belt Replacement
1. Remove the
Removal".)
2. Remove the
3. Remove the
tor).
4. Unhook the
transport belts [D].
NOTE: - When reassembling the transport belt unit, check that the transport
drive gear arm [E] is above the pin [F] as shown.
- Be sure to install the belts with the rough side out.
transport unit from the copier.
transfer and separation corona unit [A] (1 connector).
transport belt unit [B] (2 screws, 1 spring, and 1 connec-
transport belt roller [C] from the unit and replace the
(Refer to "Transport Unit
3-34