Table of Contents
Advertisement
Chapter
7
Diagnosing Problems
Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
ERROR: WRONG
OEM
ERROR: WRONG
PRINTER TYPE
ETHERNET
DETECTED
ETHERNET
INITIALIZING
H00: PCI SLOT ?
See User Manual
H01: PCI J12
See User Manual
H02: PCI J13
See User Manual
234
Can User
Explanation
Correct?
No
The SPX inserted in the
debug port is not intended
for this model printer or this
OEM.
No
The SPX inserted in the
debug port is not intended
for this model printer or this
OEM.
N/A
Status message indicating
that the Network Interface
Card has established
connection.
No
Status message: the internal
Network Interface Card is
processing the boot
procedure. (May occur with
older versions of microcode.)
No
The controller board is not
communicating with a PCI
card. This could indicate a
bad PCI card, poor
connection, or problem in
the PCI bus.
No
The controller board is not
communicating with the PCI
card in PCI slot J12. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus.
No
The controller board is not
communicating with the PCI
card in PCI slot J13. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus.
Solution
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Advertisement
Table of Contents
