Changing Parameters Example - Printronix N7000 H-Series User Manual

Changing Parameters Example

OFFLINE
QUICK
. . .
SETUP CONTROL
Factory*
1-8
Power-Up Protect
Config. Configs.
Factory* Disable*
1-8
Enable
A configuration consists of several parameters. The default factory
configuration has a starting set of parameters. In the configuration menu
above, and in all the configuration menus in this chapter, the factory default
values are indicated by an asterisk (*).
Your print jobs may require parameter values which vary from the default
settings. This section provides an example procedure for changing individual
parameter values.
The following procedure shows how to change and save the settings for the
Barcode Quality and Language options. Use these guidelines to navigate the
configuration menus and change other parameters.
NOTE: When changing Ribbon End Point parameters, all changes will apply
to every configuration saved. Changes to Ribbon End Point cannot
be saved to an individual configuration.
CONFIG.
Load Save
Config. Config.
1*
2-8
Name Reset Cfg
Configs Names
1-8 1*
2-8
All
Changing Parameters Example
* = Factory Default
Print Delete
Config. Config.
Current Short* 1*
Current Full 2-8
Factory
Power-Up
All
1-8
Auto
Save
Enable*
Disable
47