Printer Select; Esc D Command - Printronix N7000 H-Series User Manual

Chapter 4
LinePrinter+ Emulation (N7000 STD)

Printer Select

•
Disable (default). Ignores the ASCII DC1 and DC3 control codes.
•
Enable. Disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alt. Set 80-9F
•
Control Code (default). Interprets data in the range of hex 80 through
hex 9F as a control code.
•
Printable. Prints data in the range of hex 80 through hex 9F.
Character Set
Specifies a character set as shown in the "Serial Matrix Character Set Menu"
on page 101. To use one of these sets, choose the desired group heading
(such as European Sets) and press ENTER. Then choose the desired set
within that group (such as Roman 8) and press ENTER. Both the group and
the desired set will be starred to indicate your selection. Character sets are
shown in detail in the Character Sets Reference Manual.

ESC d command

•
Even dot plot (default). Interprets the ESC d command as even dot plot.
•
Double high. Interprets the ESC d Command as double high. Select this
option for backward compatibility.
100