Printronix N7000 H-Series User Manual page 113

GB High Byte
This parameter takes effect when the printer is in DBCS mode. It determines
whether the printer accepts GB data with MSB bit on or off. The values are set
to ON or OFF by the ESC k and ESC $@ commands.
•
ON (default). The printer accepts GB18030 data, the first byte below
0x80, which is a single byte ASCII character. The first byte, 0x80 and
above, is a Chinese character.
•
OFF. The printer accepts data ranging from 0x20 to 0x7F. Code points
from 0x80 and above is ignored. When DBCS Half Width mode is set by
the CEX r command, a single byte ASCII character prints. When DBCS
Half Width mode is cancelled by the CEX s command, a double byte GB
characters prints.
NOTE: This parameter is only available for Hanzi GB printers with OKI
selected.
DBCS ASCII Style
This parameter allows you to specify the appearance of the single-byte
alphanumeric characters in DBCS mode.
•
Normal (default).
•
Oversize. The alphanumeric characters will appear larger than normal
single-byte characters. For example, the appearance of character "8" will
8
be changed to " ".
•
OCRB. The alphanumeric characters will print in OCRB style. It only
takes effect on LQ typeface.
Text Position
Specifies where the text will be positioned in the line space. When set to
Top of Line, text will be positioned at the top of the line space. When set to
Bottom of Line, the text will be positioned as if it was at the bottom of a 6 lpi
line space. The following example shows both Top-of-Line and Bottom-of-Line
text positions:
Dot
Row
Top of Linespace
1
2
3
4
5
6
7
8
Bottom of 8 LPI Linespace
9
10
11
Bottom of 6 LPI Linespace 12
Text Position
Text Position
Top-of-Line
Top of Line
LinePrinter+ Emulation (N7000 H-Series)
Epson FX Emulation
1
Text Position
Text Position
Bottom-of-Line
Bottom of Line
113