Font Attributes - Printronix N7000 H-Series User Manual

Printer Protocol
Select the LinePrinter+ protocol you wish to use. Refer to the LinePrinter Plus
Programmer's Reference Manual for more information.
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values.
Host Command
This parameter allows you to block certain host commands from being
acknowledged by the printer.
•
Enable (default). All host commands are acknowledged by the printer.
•
Ignore All. All host commands are ignored by the printer.
•
Ignore CPI. All CPI commands sent by the host are ignored by the
printer.
•
Ignore LPI. All LPI commands sent by the host are ignored by the printer.
•
Ignore Unidir. All Unidirectional commands sent by the host are ignored
by the printer.

Font Attributes

Typeface
•
Data Processing (default). A general purpose font printing out at
120 dpi horizontally and 72 dpi vertically. The width of the font will vary
with each cpi.
•
NLQ. A high quality font printing at 180 dpi horizontally and
96 dpi vertically. This font has serifs and the width of the font varies with
the cpi.
•
OCR-A / OCR-B. Optical character recognition fonts printing at 120 dpi
horizontally and 144 dpi vertically. Both fonts print only at 10 cpi.
•
High Speed. A draft quality font printing at 120 dpi horizontally and 48 dpi
vertically. The width of the font varies with the cpi.
•
NLQ Sans Serif. A high quality font printing at 180 dpi horizontally and 96
dpi vertically. This font prints without serifs. The width of the font varies
with the cpi.
•
High Speed 100. A draft quality font printing at 100 dpi horizontally and
48 dpi vertically. When chosen from the front panel, it defaults to 10 cpi.
The cpi can then be varied, but the width will not change.
•
NLQ 200. This NLQ font prints at 200 dpi horizontally and 96 vertically.
When chosen from the front panel, it defaults to
12 cpi. The cpi can then be varied, but the width will not change.
•
DP 200. This Data Processing font prints at 200 dpi horizontally and 72
vertically. When chosen from the front panel, it defaults to 12 cpi. The cpi
can then be varied, but the width will not change.
LinePrinter+ Emulation (N7000 STD)
87