Fuji Xerox DocuScan C4250 User Manual page 59

Loading the Document and Inserting the Media
1. Load the document to be scanned.
Refer to
• For instructions on how to load documents, refer to
"1.5 Loading Documents (P. 23)".
2. Insert a USB flash memory into the USB
connector.
Note
• The scanner has three USB connectors. To insert a
USB flash memory, the connector located on the front
side is the most convenient. Other USB connectors
can be used also if the connector on the front side has
malfunctioned.
Refer to
• For more information on the location of the USB
connectors, refer to "1.1 Main Components (P. 13)".
Setting the File Name
Selecting [Change File Name...] on the [Save In] screen displays the [Change File Name]
screen. On this screen, you can set the file name of the scanned data and specify the action
to be taken when a file name conflict occurs.
More Scan
Save In Basic Scanning
Features
Change File Name...
Insert a USB Flash
Memory as shown
on the left.
File Name
Set the file name of the scanned data.
If you leave this blank, the file name will be assigned automatically based on the following
rule:
• Starts with "img-" followed by a nine-digit number indicating the saved date and time.
October, November, and December, however, are indicated as "X", "Y", and "Z",
respectively.
Example: img-102030400
img-X11123045
When entering the file name, follow the guidelines below:
• Enter it within 20 characters or symbols.
• The following symbols cannot be used:
* " / \ < > : | ? = , . ; [ ] +
Preview
January 2nd, 03:04:00 (hr:min:sec)
October 11th, 12:30:45 (hr:min:sec)
Change File Name
Cancel
File Name (Max. 20 chars.)
(Auto Set)
Restore Auto
File Name Conflict
Change Name and Save
2.6 Using Scan to Media
Save
59