Fuji Xerox DocuScan C4250 User Manual page 29

Using the Document Feeder (DocuScan C3200 A)
Up to 50 sheets of documents (plain paper: 60-100 g/m
140.0 mm to 215.9 x 355.6 mm can be loaded at once using the document feeder. When
scanning more than 50 sheets, load 50 sheets or less at a time.
Note
• When scanning more than 50 sheets, select [Next Original] while the first 50 sheets are being scanned,
and load the next 50 sheets or less to scan all documents as a single job. For more information, refer to
" Step 5 Start the scan job (P. 33)" or " Step 6 Start the copy job (P. 81)".
The document feeder feeds documents from the top of the stack and outputs them face
down. Use the following procedure to load documents into the document feeder.
1. Remove all staples and paper clips from the documents and align their edges.
2. Insert the documents into the document
feeder face up (If the documents are 2-
sided, their front sides should face up).
Make sure that the documents are loaded
all the way into the document feeder.
3. Position the document guides to just touch
the edge of the documents.
Important
• Keep the followings in mind to prevent the
documents from being jammed or damaged:
• Do not hold the documents while they are being
fed into the document feeder.
• Constantly remove the documents from the
document output tray after they are output (Do
not leave them on the tray until they are piled up).
• Do not put any objects on the document output tray.
2
) of sizes ranging from 140.0 x
1.5 Loading Documents
29