Hardware Problems - Fuji Xerox DocuScan C4250 User Manual

8.3

Hardware Problems

Before concluding that your scanner has malfunctioned, check the following table to see if
you can resolve your problem.
The scanner will not
switch on.
The touch panel is too
dark.
The scanner will not
scan or copy.
Symptom
Is the power switched on?
Is the power cord plugged into the
power outlet?
Is the power cord plugged into the
power cord connector?
If the power of correct voltage
being supplied?
Is the <Power Saver> button lit?
Is a message displayed on the
touch panel?
Is the power cord plugged into the
power cord connector?
If the scanner will not scan while
using the Scan to E-mail or Scan
to PC feature, is the network
cable plugged in?
Cause
Switch on the power.
Refer to
• " Switching On the Power (P. 21)"
Switch the power off, firmly plug in the
power cord, and then switch the
power back on.
Refer to
• "Installing the Scanner" in the Setup
Connect the scanner to a power outlet
that supplies the correct voltage.
Refer to
• "Safety Note" in the Setup and
The scanner is in the Power Saver
mode. Press the <Power Saver> but-
ton on the control panel to exit the
Power Saver mode.
Refer to
• "1.4 Setting/Exiting the Power
Follow the message to remedy the
problem.
Switch the power off, firmly plug in the
power cord, and then switch the
power back on.
Refer to
• "Installing the Scanner" in the Setup
Plug the network cable firmly into the
connector.
Refer to
• "Installing the Scanner" in the Setup
Remedy
and Quick Reference Guide
Quick Reference Guide
Saver Mode (P. 22)"
and Quick Reference Guide
and Quick Reference Guide
8.3 Hardware Problems
199