Fuji Xerox DocuScan C4250 User Manual page 28

Important
• When scanning a thick document, do not press it hard against the document glass. The document
glass may break and injure you.
• When scanning with the document feeder cover open, do not stare at the scan light. The light may
cause eye irritation or fatigue.
Using the Document Feeder (DocuScan C4250)
Up to 50 sheets of documents (plain paper: 60-100 g/m
148.0 mm to 297.0 x 432.0 mm can be loaded at once using the document feeder. When
scanning more than 50 sheets, load 50 sheets or less at a time.
Note
• When scanning more than 50 sheets, select [Next Original] while the first 50 sheets are being scanned,
and load the next 50 sheets or less to scan all documents as a single job. For more information, refer to
" Step 5 Start the scan job (P. 33)" or " Step 6 Start the copy job (P. 81)".
The document feeder feeds documents from the top of the stack and outputs them face
down. Use the following procedure when loading documents into the document feeder.
1. Remove all staples and paper clips from the documents and align their edges.
2. Insert the documents into the document
feeder face up, and align them with the left
and rear edges of the document feeder tray.
When the documents are loaded correctly,
the document indicator lamp lights up.
3. Position the document guide to just touch
the edge of the documents.
Important
• Keep the followings in mind to prevent the
documents from being jammed or damaged:
• Do not hold the documents while they are being
• Constantly remove the documents from the
• Do not put any objects on the document output tray.
28
1 Basic Operation
fed into the document feeder.
document output tray after they are output (Do
not leave them on the tray until they are piled up).
2
) of sizes ranging from 100.0 x