Table of Contents
Advertisement
Using Reset Levels
The SMX can be returned to default settings by choosing certain reset modes. This can be
done via the front panel or the recessed Reset button on the rear panel (see c on
Using the Front Panel
The front panel reset is identical to the
SIS command on page 51). This clears all ties, presets, and mutes; resets all RGB delay to
0 seconds; resets all input audio levels to unity gain (0 dB); and sets all output volume levels
to 100% (0 dB of attenuation).
NOTE:
To initiate the reset, perform the following:
1.
2.
3.
Using the Rear Panel
The recessed reset button on the rear panel initiates four levels of resets (numbered 1, 3,
4, and 5). Use a pointed stylus or Extron Tweeker to press it and select a reset level (see the
Reset Modes Table
down, the I/O light blinks every 3 seconds as the next reset level is reached, corresponding to
modes 3, 4, and 5. Use mode 1 if compatibility issues arise with user-loaded firmware.
CAUTION: After a mode 1 reset is performed, update the firmware to the latest version.
If mode 1 is selected by mistake, cycle power to the SMX to return to the firmware version
that was running before the reset. Use the
default firmware is no longer running (look for the asterisk [*] following the version number).
•
•
•
•
This system reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
•
To save settings, use the SMX Control Program and the
command (see
settings as...
If necessary, disconnect the power.
Press and hold the View and Esc buttons while reapplying AC power to the SMX.
C O N T R O L
ENTER
PRESET
VIEW
ESC
Figure 27.
Front Panel System Reset
Continue to hold the View and Esc buttons until the SMX properly powers up (see
Powering Up
on page 16) and then release the buttons.
on page 32 for the modes). If the reset button is continuously held
Do no operate the SMX with the firmware version that results from the
mode 1 reset. To use the factory default firmware, upload that version again.
Use mode 3 to restart the communication and control events.
Use mode 4 to reset most IP protocols to their default settings.
Use mode 5 to restore the switcher to the default conditions.
E
}
ZXXX
SIS command (see the
Save MATRIX settings as...
Power
SIS command
to confirm that the factory
0Q
SMX System MultiMatrix Switcher • Operation
page
8).
Reset Switcher
File > Save MATRIX
on page 63).
31
Advertisement
Table of Contents
