Table of Contents
Advertisement
3.
Using Emulation Mode
Emulation mode allows you to set up the software without attaching the SMX to the
computer. To use Emulation mode, do the following:
1.
2.
3.
If you select a comm port, click
•
on page 62.
If you selected IP [LAN], click
•
If you selected Emulate, click
•
section on page 61.
in step 2, the IP Connection window opens.
If you selected
IP [LAN]
a.
The
Matrix IP Address
list to the right contains the most recently used IP addresses.
Select the desired IP address from the list or enter it in the field.
NOTE:
192.168.254.254 is the factory-specified default IP address.
b.
If the SMX is password-protected, enter the appropriate administrator or user
password in the
Password
c.
Click
Connect
. The SMX Control Program is ready for operation.
If you logged on using an administrator password, the Windows program
•
connects to the SMX with all of the administrator rights and privileges.
If you logged on with a user password, the Windows program connects you to
•
the SMX with only user capabilities.
If an incorrect password is entered, the program beeps and returns to the
•
password entry dialog box.
Open the SMX Control Program (see
From the Comm Port Selection window, select
Choose an emulation file to open and click
a sample of a completed matrix setup. Selecting the file NEW.INI or clicking
provides a blank setup.
SMX System MultiMatrix Switcher • SMX Control Software
OK
and proceed to the
and proceed to step 3.
OK
and proceed to the
Using Emulation Mode
OK
field defaults to the last IP address entered. A drop-down
field.
Starting the Program
Emulate
and click
. The file DEMO_SMX10.MTX provides
OK
Using the Program
section
on page 60)
OK
.
Cancel
61
Advertisement
Table of Contents
