Table of Contents
Advertisement
Mode 1
Press and hold
the Reset button.
Modes 3, 4, and 5
Press and hold for
3, 6, or 9 seconds.
Figure 28.
CAUTION: Review the reset modes carefully. Using the wrong reset mode may result
NOTE:
Mode Activation
1.
Hold down the recessed Reset button while
applying power to the SMX.
NOTE:
After a mode 1 reset is performed,
update the SMX firmware to the
latest version. Do not operate the
firmware version that results from
this mode reset. If you want to
use the factory default firmware,
upload that version again (see
page 83
page 96
or
uploading firmware).
3.
Hold down the Reset button for about
3 seconds until the Power LED flashes once,
then release and press Reset momentarily
(less than 1 second).
4.
Hold down the reset button for about 6
seconds until the Power LED flashes twice
(once at 3 seconds and again at 6 seconds).
Then release and press Reset momentarily
(for less than 1 second).
NOTE:
Nothing happens if the momentary
press does not occur within 1
second.
5.
Hold down the Reset button for about
9 seconds until the Power LED flashes
three times (once at 3 seconds, again at
6 seconds, and then at 9 seconds). Then
release and press Reset momentarily (for
less than 1 second) within 1 second.
Reset LED flashes once,
twice, or three times.
Resetting the SMX
in unintended loss of flash memory programming, port reassignment, or
processor reboot.
The reset modes listed in the table below close all open IP and Telnet connections
and all sockets. Each mode is a separate function, not a continuation from mode
1 to mode 5.
SMX Series MultiMatrix Switcher Reset Mode Summary
The SMX reverts to the factory default
firmware. Event scripting does not start if the
SMX is powered on in this mode. All user files and
settings (drivers, adjustments, IP settings, and so on)
are maintained.
NOTE:
for details on
This mode turns events on or off.
NOTE:
This Mode:
•
Enables ARP capability.
•
Sets the IP address back to factory default
(192.168.254.254).
•
Sets the subnet back to factory default.
•
Sets the default gateway address to factory
default.
•
Sets port mapping back to factory default.
•
Turns DHCP off.
•
Turns events off.
This mode performs a complete reset to factory
defaults (except the firmware).
•
Does everything mode 4 does.
•
Removes button or touchpanel configurations.
•
Resets all IP options.
•
Removes scheduling settings.
•
Removes all files from the SMX.
Release the Reset button.
2
1
Apply Power
Release, then immediately
press and release again. Reset
LED flashes in confirmation.
Result
If you do not want to update firmware,
or if you performed a mode 1 reset
by mistake, cycle power to the SMX
to return to the firmware version that
was running prior to the mode 1 reset.
Use the 0Q SIS command to confirm
that the factory default firmware is
no longer running (look for asterisks
following the version number).
Nothing happens if the momentary
press does not occur within 1 second.
SMX System MultiMatrix Switcher • Operation
Purpose/Notes
This mode reverts to the
factory default firmware
version if incompatibility
issues arise with user-
loaded firmware.
NOTE:
User-defined
web pages
may not
work
correctly
if using
an earlier
firmware
version.
This mode is useful for
troubleshooting.
This mode enables you to
set IP address information
using ARP and the MAC
address.
This mode is useful if
you want to start over
with configuration and
uploading, and also to
replace events.
32
Advertisement
Table of Contents
