Table of Contents
Advertisement
Audio-Input Gain settings — Select this to change
•
the audio gain (0.5 dB steps) for all or single inputs.
To change the gain, pick an input (or
adjustment arrows to raise or lower the gain.
NOTE:
Click on the applicable Changes radio
buttons to have any changes either
immediate or verifiable.
(default setting) accepts changes
Verify
after the
Take
accepts changes instantly.
Immediate
The
button is removed.
Take
Click
Take
(if visible) to accept the changes.
•
Click
Use Defaults
•
Click
Cancel Change
•
•
Audio Output Volume settings — Select this option to change the audio volume
(in 1% steps) for all or single outputs.
To change the volume, pick an output (or
lower the volume slider.
NOTE:
When an RGB input is connected, this menu
also shows the RGB delay settings (see
Delay settings
Click
Close
to exit the window.
To mute video or audio output, select either check box in the Mute box per selected
output number (or
All
Mute Output settings — Select this option to mute any or
•
all video or audio outputs.
To mute a video or audio signal, select an output (or
and check the video or audio mute box. The output is now
muted, and the output box in the main window indicates
the mute status.
Click
to exit the window.
Close
NOTE:
When an RGB input is connected, this menu also shows the RGB Delay
settings (see
•
HD-SDI Re-clocker Rate settings — Select this option
to reset the reclocking rate for HD-SDI inputs. The Re-
clocker rate sets the outputs in sync with input signals.
If an audio board is set to the plane address, a slider will
become available for volume adjustment in this dialog
box.
) and use the
All
button is pressed.
to set the selected input to the default setting.
to return the gain to the previous setting.
All
) and raise or
RGB
on page 65).
).
RGB Delay settings
on page 65).
SMX System MultiMatrix Switcher • SMX Control Software
)
All
66
Advertisement
Table of Contents
