Table of Contents
Advertisement
4.
Press and release a desired output button. The button lights green. The output audio
volume (relative volume) is indicated by the number of lit input buttons. All buttons lit
indicates no (zero) attenuation.
5.
Press and release the Esc (>) and View (<) buttons to increase or decrease the output
audio volume (see the
Audio Output Volume Lighting Table
6.
If desired, select additional outputs by pressing their output buttons.
7.
Press and release the Enter button (or wait 30 seconds) to exit the audio display and
adjustment mode. The audio plane button extinguishes.
Step 4 – Press the button for the output needing the audio volume adusted (here 3).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
The selected output button lights green.
The current audio volume is indicated by the lit and flashing input buttons.
Here input buttons 1-16 lit green indicate an output volume of 100% (0 dB attentuation).
Step 5 – Press and hold View to decrease or Esc to increase audio level (here View).
C O N T R O L
VIEW
ESC
ENTER
PRESET
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
The selected output button remains lit. Inputs light, flash, or go out as the volume changes.
Here the volume is decreased to 65.5%. Inputs 1-10 are lit green, and 11 is flashing slowly.
Additional outputs can be adjusted by repeating steps 4 and 5.
Step 6 – Press Enter to leave the output audio volume adjustment mode.
All buttons go out.
Figure 26.
Adjusting the Output Volume — an Example (Steps 4 through 6)
NOTE:
There is only one audio volume setting per output on any specific plane. The
audio volume is shared by the left and right audio outputs. The audio volume
is stored in non-volatile memory. When power is removed and restored, the
audio volume settings are retained.
If the audio is set to "follow-all," upon initial selection (step 2) the I/O plane
and associated input and output buttons light amber. When an input or
output button is held for 2 seconds (step 3), the I/O plane button flashes red.
INPUTS
OUTPUTS
INPUTS
OUTPUTS
SMX System MultiMatrix Switcher • Operation
on page 30 for settings).
29
Advertisement
Table of Contents
