To Set or Replace Ties
1.
Select the desired plane from the drop-down list (see
NOTE:
When you select a plane, only the available adjustment fields show on the
screen, according to the output board type installed and addressed.
1
3
Figure 58.
Control Pages — User Control Page
2.
In the Signal Type section, click
depending on the signal type to be tied.
NOTE:
When viewing the ties on the User Control page, video ties are shown
green, audio ties are red, and video and audio ties amber (see
3.
Click the desired input or output button in the Set & View Ties map. The button
changes color according to signal type and indicates a provisional tie with a letter "P"
figure
58, input 6, output 7, for example).
(see
NOTE:
An existing tie to an input is replaced by the new input tie. Click
abandon changes and revert back to the existing ties.
4.
Click
Take
to make the ties. The page refreshes, the letter "P" disappears from the
button and the SMX is updated with the new tie.
To Remove Ties
1.
Select the desired plane from the drop-down list.
2.
In the Signal Type section, click
depending on the signal type to be removed.
3.
Click the input or output button of the tie to be removed. The button changes color and
indicates a provisional tie with a letter "P" (see
SMX System MultiMatrix Switcher • HTML Configuration and Control
figure
2
,
, or
Video only
Audio only
,
, or
Video only
Audio only
figure
58).
58).
,
Video & Audio
figure
58).
to
Cancel
,
Video & Audio
99