Table of Contents
Advertisement
4.
5.
6.
Using the Program
At startup, the SMX Control Program window appears (see
the current configuration of the SMX (the numbered boxes represent the video and audio
inputs and outputs and initially opens at the lowest plane). Each plane has a separate
numbered tab from 0-15, that are shown at the right side of the main window (in the
example below, only planes 0 and 1 are being used).
NOTE:
Figure 30.
Select the file name under which you want to save any changes to the file and click
The SMX Physical Configuration [Emulation Mode] window appears.
Select the signal type boards, board sizes, plane addresses, and matrix model for which
you are preparing a configuration and click
The SMX Control Program window opens (see
Each SMX system configuration varies per installation. The screens shown
throughout this section may look different from the ones displayed on your
computer.
Video Inputs and Outputs on Plane 0 — No Ties
SMX System MultiMatrix Switcher • SMX Control Software
.
Take
Using the Program
below).
figure
30). The window displays
OK
.
62
Advertisement
Table of Contents
