Common System Command Input Values; Http/Https Commands - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 33 System Remote Management

33.2 Common System Command Input Values

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 118 Input Values for General System Commands
LABEL
address_object
rule_number
zone_object

33.3 HTTP/HTTPS Commands

The following table describes the commands available for HTTP/HTTPS. You must use the
configure terminal
commands.
Table 119 Command Summary: HTTP/HTTPS
COMMAND
[no] ip http authentication auth_method
[no] ip http port <1..65535>
[no] ip http secure-port <1..65535>
[no] ip http secure-server
[no] ip http secure-server auth-client
208
DESCRIPTION
The name of the IP address (group) object. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the first character cannot be a number.
_
This value is case-sensitive.
The number of a service control rule. 1 - X where X is the highest number of rules the
UAG model supports.
The name of the zone. Use up to 31 characters (a-zA-Z0-9_-). The name cannot start
with a number. This value is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2, SSL VPN, IPSec VPN,
and WAN.
command to enter the configuration mode before you can use these
DESCRIPTION
Sets an authentication method used by the HTTP/HTTPS
server. The command resets the authentication
no
method used by the HTTP/HTTPS server to the factory
default ( ).
default
auth_method: The name of the authentication method.
You may use 1-31 alphanumeric characters,
underscores(_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
Sets the HTTP service port number. The
resets the HTTP service port number to the factory
default (80).
Sets the HTTPS service port number. The
resets the HTTPS service port number to the factory
default (443).
Enables HTTPS access to the UAG web configurator. The
command disables HTTPS access to the UAG web
no
configurator.
Sets the client to authenticate itself to the HTTPS server.
The command sets the client not to authenticate itself
no
to the HTTPS server.
command
no
command
no
UAG CLI Reference Guide