Link Sticking Command Example - ZyXEL Communications UAG Series Cli Reference Manual

mode before you can use these commands. See
you can input with these commands.
Table 32 ip load-balancing link-sticking Commands Summary
COMMAND
[no] ip load-balancing link-sticking activate
[no] ip load-balancing link-sticking timeout
timeout
show ip load-balancing link-sticking status

7.8 Link Sticking Command Example

This example shows how to activate link sticking and set the timeout to 600 seconds (ten minutes).
Router(config)# ip load-balancing link-sticking activate
Router(config)# ip load-balancing link-sticking timeout 600
Router(config)# show ip load-balancing link-sticking status
active : yes
timeout : 300
UAG CLI Reference Guide
Table 30 on page 76
DESCRIPTION
Turns link sticking on or off.
Sets for how many seconds (30-3600) the UAG sends all of each
local computer's traffic through one WAN interface.
Displays the current link sticking settings.
Chapter 7 Trunks
for details about the values
79