Vpn-1-1-Map Pool Sub-Commands; Vpn-1-1-Map Pool Command Examples; Vpn-1-1-Map Rule Sub-Commands - ZyXEL Communications UAG Series Cli Reference Manual

13.2.1 vpn-1-1-map pool Sub-commands

The following table describes the sub-commands for the vpn-1-1-map pool command.
Table 53 vpn-1-1-map pool Sub-commands
COMMAND
address address_object
exit
interface interface_name

13.2.2 vpn-1-1-map pool Command Examples

The following commands create a pool profile and display the settings.
Router# configure terminal
Router(config)# vpn-1-1-map pool pool1
Router(vpn-1-1-map-pool-pool1)# address WAN-1
Router(vpn-1-1-map-pool-pool1)# interface wan1
Router(vpn-1-1-map-pool-pool1)# exit
Router(config)# show vpn-1-1-map pool
Pool: pool1
address: WAN-1
interface: wan1
Router(config)#

13.2.3 vpn-1-1-map rule Sub-commands

The following table describes the sub-commands for several vpn-1-1-map rule commands. Note
that not all rule commands use all the sub-commands listed here.
Table 54 vpn-1-1-map rule Sub-commands
COMMAND
activate
deactivate
exit
flush pool
UAG CLI Reference Guide
DESCRIPTION
Configures the name of the IP address object the profile is set to use.
An address object presents the IP address(es), which can be assigned
to the matched users by the UAG.
Note: You cannot configure an address group object at the time of
writing.
Note: It's recommended that the IP addresses of the configured
address object and the WAN interface are in the same subnet
so that the UAG can receive response packets from the remote
node.
Leaves the sub-command mode.
Sets the interface through which the UAG sends traffic from the
matched users.
DESCRIPTION
Enables the VPN 1-1 mapping rule.
Disables the VPN 1-1 mapping rule.
Leaves the sub-command mode.
Removes all pool profile(s) and resets the pool profile setting to the
default (any). any means all IP address.
Chapter 13 VPN 1-1 Mapping
107