Dhcp Setting Commands - ZyXEL Communications UAG Series Cli Reference Manual

This example shows how to restart an interface. You can check all interface names on the UAG.
Then use either the system name or user-defined name of an interface (ge4 or Customer in this
example) to restart it.
Router> show interface-name
No. System Name
===========================================================================
1 ge1
2 ge2
3 ge3
4 ge4
5 ge5
Router> configure terminal
Router(config)# interface reset ge4
Router(config)# interface reset Customer
Router(config)#

6.2.2 DHCP Setting Commands

This table lists DHCP setting commands. DHCP is based on DHCP pools. Create a DHCP pool if you
want to assign a static IP address to a MAC address or if you want to specify the starting IP address
and pool size of a range of IP addresses that can be assigned to DHCP clients. There are different
commands for each configuration. Afterwards, in either case, you have to bind the DHCP pool to the
interface.
Table 15 interface Commands: DHCP Settings
COMMAND
show ip dhcp dhcp-options
show ip dhcp pool [profile_name]
show ip dhcp pool profile_name dhcp-options
ip dhcp pool rename profile_name
profile_name
[no] ip dhcp pool profile_name
show
UAG CLI Reference Guide
User Defined Name
wan1
wan2
lan1
Customer
dmz
DESCRIPTION
Shows the DHCP extended option settings.
Shows information about the specified DHCP pool or about all DHCP
pools.
Shows the specified DHCP pool's DHCP extended option settings.
Renames the specified DHCP pool from the first profile_name to the
second profile_name.
Creates a DHCP pool if necessary and enters sub-command mode.
You can use the DHCP pool to create a static entry or to set up a
range of IP addresses to assign dynamically.
About the sub-command settings:
• If you use the host command, the UAG treats this DHCP pool as a
static DHCP entry.
• If you do not use the host command and use the network
command, the UAG treats this DHCP pool as a pool of IP
addresses.
• If you do not use the host command or the network command,
the DHCP pool is not properly configured and cannot be bound to
any interface.
The no command removes the specified DHCP pool.
Shows information about the specified DHCP pool.
Use the following commands to create a static DHCP entry. If you do
not use the host command, the commands that are not in this
section have no effect, but you can still set them.
Chapter 6 Interfaces
59