Rip Commands; General Ospf Commands - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 9 Routing Protocol

9.2.1 RIP Commands

This table lists the commands for RIP.
Table 39 router Commands: RIP
COMMAND
router rip
[no] network interface_name
[no] redistribute {static | ospf}
redistribute {static | ospf} metric <0..16>
[no] version <1..2>
[no] passive-interface interface_name
[no] authentication mode {md5 | text}
[no] authentication string authkey
authentication key <1..255> key-string authkey
no authentication key
[no] outonly-interface interface_name

9.2.2 General OSPF Commands

This table lists the commands for general OSPF configuration.
Table 40 router Commands: General OSPF Configuration
COMMAND
router ospf
[no] redistribute {static | rip}
[no] redistribute {static | rip} metric-
type <1..2> metric <0..16777214>
[no] passive-interface interface_name
[no] router-id IP
90
DESCRIPTION
Enters sub-command mode.
Enables RIP on the specified Ethernet interface. The
command disables RIP on the specified interface.
Enables redistribution of routing information learned from
the specified source. The
redistribution from the specified source.
Sets the metric when redistributing routing information
learned from the specified source.
Sets the default RIP version for all interfaces with RIP
enabled. If the interface RIP version is blank, the interface
uses the default version. This is not available in the GUI.
The command sets the default RIP version to 2.
no
Sets the direction to "In-Only" for the specified interface.
The command sets the direction to bi-directional.
no
Sets the authentication mode for RIP. The
sets the authentication mode to "none".
Sets the password for text authentication. The
command clears the password.
Sets the MD5 ID and password for MD5 authentication.
Clears the MD5 ID and password.
Sets the direction to "Out-Only" for the specified interface.
The command sets the direction to "BiDir".
no
DESCRIPTION
Enters sub-command mode.
Enables redistribution of routing information learned from the
specified non-OSPF source. The
from the specified non-OSPF source.
Sets the metric for routing information learned from the specified
non-OSPF source. The command clears the metric.
no
Sets the direction to "In-Only" for the specified interface. The
command sets the direction to "BiDir".
Sets the 32-bit ID (in IP address format) of the UAG. The
command resets it to "default", or the highest available IP address.
command disables
no
command
no
no
command disables redistribution
no
no
UAG CLI Reference Guide
no
no