Zone Commands Summary - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 10 Zones

10.2 Zone Commands Summary

The following table describes the values required for many zone commands. Other values are
discussed with the corresponding commands.s
Table 44 Input Values for Zone Commands
LABEL
profile_name
This table lists the zone commands.
Table 45 zone Commands
COMMAND
show zone [profile_name]
show zone binding-iface
show zone default-binding Displays the pre-configured interface and zone mappings that come with the
show zone none-binding
show zone system-default
show zone user-define
[no] zone profile_name
zone profile_name
[no] block
[no] interface
interface_name
[no] crypto
profile_name
[no] sslvpn
profile_name
94
DESCRIPTION
The name of a zone, or the name of a VPN tunnel.
Use up to 31 characters (a-zA-Z0-9_-). The name cannot start with a number. This value
is case-sensitive.
About the pre-defined zones in the UAG:
• The lan1 interface always belongs to the LAN1 zone.
• The lan2 interface always belongs to the LAN2 zone.
• The dmz interface always belongs to the DMZ zone.
• The wan1, wan2, wan1_ppp, or wan2_ppp interfaces always belong to the WAN zone.
DESCRIPTION
Displays information about the specified zone or about all zones.
Displays each interface and zone mappings.
UAG.
Displays the interfaces, tunnels and SSL VPNs that are not associated with a
zone yet.
Displays the pre-configured default zones that you cannot delete from the
UAG.
Displays all customized zones.
Creates the zone if necessary and enters sub-command mode. The no
command deletes the zone.
Enter the sub-command mode.
Blocks intra-zone traffic. The
Adds the specified interface to the specified zone. The
the specified interface from the specified zone. See
information about interface names.
Adds the specified IPSec VPN tunnel to the specified zone. The no command
removes the specified IPSec VPN tunnel from the specified zone.
Adds the specified SSL VPN tunnel to the specified zone. The no command
removes the specified SSL VPN tunnel from the specified zone.
command allows intra-zone traffic.
no
no
Section 6.2 on page 55
UAG CLI Reference Guide
command removes
for