Common System Command Input Values; Http/Https Commands - ZyXEL Communications ZYWALL USG CLI Reference Manual

Chapter 34 System Remote Management

34.2 Common System Command Input Values

The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
Table 152 Input Values for General System Commands
LABEL
address_object
rule_number
zone_object

34.3 HTTP/HTTPS Commands

The following table describes the commands available for HTTP/HTTPS. You must use the
configure terminal
commands.
Table 153 Command Summary: HTTP/HTTPS
COMMAND
[no] ip http authentication auth_method
[no] ip http port <1..65535>
[no] ip http secure-port <1..65535>
[no] ip http secure-server
[no] ip http secure-server auth-client
258
DESCRIPTION
The name of the IP address (group) object. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the first character cannot be a
_
number. This value is case-sensitive.
The number of a service control rule. 1 - X where X is the highest number of rules
the ZyWALL model supports.
The name of the zone. For the ZyWALL USG 300 and above, use up to 31
characters (a-zA-Z0-9_-). The name cannot start with a number. This value is
case-sensitive.
The ZyWALL USG 100 and 200 models use pre-defined zone names like DMZ,
LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.
command to enter the configuration mode before you can use these
DESCRIPTION
Sets an authentication method used by the
HTTP/HTTPS server. The no
the authentication method used by the HTTP/
HTTPS server to the factory default (
auth_method: The name of the authentication
method. You may use 1-31 alphanumeric
characters, underscores(_), or dashes (-), but the
first character cannot be a number. This value is
case-sensitive.
Sets the HTTP service port number. The
command resets the HTTP service port number
to the factory default (80).
Sets the HTTPS service port number. The
command resets the HTTPS service port number
to the factory default (443).
Enables HTTPS access to the ZyWALL web
configurator. The no command disables HTTPS
access to the ZyWALL web configurator.
Sets the client to authenticate itself to the HTTPS
server. The command sets the client not to
no
authenticate itself to the HTTPS server.
ZyWALL (ZLD) CLI Reference Guide
command resets
).
default
no
no