ZyXEL Communications UAG Series Cli Reference Manual page 60

Chapter 6 Interfaces
Table 15 interface Commands: DHCP Settings (continued)
COMMAND
[no] host ip
[no] hardware-address mac_address
[no] client-identifier mac_address
[no] client-name host_name
dhcp-option <1..254> option_name
{boolean <0..1>| uint8 <0..255> |
uint16 <0..65535>
| uint32 <0..4294967295> | ip ipv4 [
ipv4 [ ipv4]] | fqdn fqdn [ fqdn [
fqdn]] | text text | hex hex | vivc
enterprise_id hex_s [enterprise_id
hex_s ] | vivs enterprise_id hex_s
[enterprise_id hex_s ]
no dhcp-option <1..254>
network IP/<1..32>
network ip mask
no network
[no] default-router ip
[no] description description
[no] domain-name domain_name
60
DESCRIPTION
Specifies the static IP address the UAG should assign. Use this
command, along with hardware-address, to create a static DHCP
entry.
Note: The IP address must be in the same subnet as the interface to
which you plan to bind the DHCP pool.
When this command is used, the UAG treats this DHCP pool like a
static entry, regardless of the network setting. The no command
clears this field.
Reserves the DHCP pool for the specified MAC address. Use this
command, along with host, to create a static DHCP entry. The no
command clears this field.
Specifies the MAC address that appears in the DHCP client list. The
command clears this field.
no
Specifies the host name that appears in the DHCP client list. The no
command clears this field.
host_name: You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a
_
number. This value is case-sensitive.
Use the following commands to create a pool of IP addresses. These
commands have no effect if you use the host command. You can still
set them, however.
Adds or edits a DHCP extended option for the specified DHCP pool.
text: String of up to 250 characters
hex: String of up to 250 hexadecimal pairs.
vivc: Vendor-Identifying Vendor Class option. A DHCP client may use
this option to unambiguously identify the vendor that manufactured
the hardware on which the client is running, the software in use, or
an industry consortium to which the vendor belongs.
enterprise_id: Number <0..4294967295>.
hex_s: String of up to 120 hexadecimal pairs.
vivs: Vendor-Identifying Vendor-Specific option. DHCP clients and
servers may use this option to exchange vendor-specific information.
Removes the DHCP extended option for the specified DHCP pool.
Specifies the IP address and subnet mask of the specified DHCP pool.
The subnet mask can be written in w.x.y.z format or in /<1..32>
format.
Note: The DHCP pool must have the same subnet as the interface to
which you plan to bind it.
The command clears these fields.
no
Specifies the default gateway DHCP clients should use. The no
command clears this field.
Specifies a description for the DHCP pool for identification. The no
command removes the description.
Specifies the domain name assigned to DHCP clients. The no
command clears this field.
UAG CLI Reference Guide