Basic Interface Properties And Ip Address Commands - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 6 Interfaces

6.2.1 Basic Interface Properties and IP Address Commands

This table lists basic properties and IP address commands.
Table 14 interface General Commands: Basic Properties and IP Address Assignment
COMMAND
show interface {ethernet | vlan | bridge
| ppp | auxiliary} status
show interface {interface_name | ethernet
| vlan | bridge | ppp | virtual ethernet |
virtual vlan | virtual bridge | all}
show interface send statistics interval
show interface summary all
show interface summary all status
[no] interface interface_name
[no] description description
[no] downstream <0..1048576>
exit
[no] ip address dhcp
[no] ip address ip subnet_mask
[no] ip gateway ip
ip gateway ip metric <0..15>
[no] metric <0..15>
[no] mss <536..1460>
[no] mtu <576..1500>
[no] shutdown
traffic-prioritize {tcp-ack|content-
filter|dns|ipsec-vpn|ssl-vpn}
bandwidth <0..1048576> priority
<1..7> [maximize-bandwidth-usage];
56
DESCRIPTION
Displays the connection status of the specified type of interfaces.
Displays information about the specified interface, specified type of
interfaces, or all interfaces.
Displays the interval for how often the UAG refreshes the sent packet
statistics for the interfaces.
Displays basic information about the interfaces.
Displays the connection status of the interfaces.
Creates the specified interface if necessary and enters sub-command
mode. The command deletes the specified interface.
no
Specifies the description for the specified interface. The
clears the description.
description: You can use alphanumeric and
characters, and it can be up to 60 characters long.
This is reserved for future use.
Specifies the downstream bandwidth for the specified interface. The
command sets the downstream bandwidth to 1048576.
Leaves the sub-command mode.
Makes the specified interface a DHCP client; the DHCP server gives the
specified interface its IP address, subnet mask, and gateway. The
command makes the IP address static IP address for the specified
interface. (See the next command to set this IP address.)
Assigns the specified IP address and subnet mask to the specified
interface. The command clears the IP address and the subnet mask.
no
Adds the specified gateway using the specified interface. The
command removes the gateway.
Sets the priority (relative to every gateway on every interface) for the
specified gateway. The lower the number, the higher the priority.
Sets the PPPoE/PPTP interface's priority relative to other interfaces. The
lower the number, the higher the priority.
Specifies the maximum segment size (MSS) the interface is to use. MSS
is the largest amount of data, specified in bytes, that the interface can
handle in a single, unfragmented piece. The
interface use its default MSS.
Specifies the Maximum Transmission Unit, which is the maximum
number of bytes in each packet moving through this interface. The UAG
divides larger packets into smaller fragments. The
the MTU to 1500.
Deactivates the specified interface. The
Applies traffic priority when the interface sends TCP-ACK traffic, traffic
for querying the content filter, traffic for resolving domain names, or
encrypted traffic for an IPSec or SSL VPN tunnel. It also sets how much
bandwidth the traffic can use and can turn on maximize bandwidth
usage.
command
no
()+/:=?!*#@$_%-
no
no
command has the
no
command resets
no
command activates it.
no
UAG CLI Reference Guide
no