ZyXEL Communications UAG Series Cli Reference Manual page 65

Table 18 interface Commands: OSPF Settings (continued)
COMMAND
[no] ip ospf dead-interval <1..65535>
[no] ip ospf retransmit-interval
<1..65535>
UAG CLI Reference Guide
DESCRIPTION
Sets the number of seconds the UAG waits for "hello" messages from
peer routers before it assumes the peer router is not available and
deletes associated routing information. The
number of seconds to 40. See ip ospf hello-interval for more
information.
Sets the number of seconds the UAG waits for an acknowledgment in
response to a link state advertisement before it re-sends the
advertisement.
Link state advertisements (LSA) are used to share the link state and
routing information between routers.
Chapter 6 Interfaces
command sets the
no
65