System Remote Management; Remote Management Overview; Remote Management Limitations; System Timeout - ZyXEL Communications UAG Series Cli Reference Manual

This chapter shows you how to determine which services/protocols can access which UAG zones (if
any) from which computers.
Note: To access the UAG from a specified computer using a service, make sure no
service control rules or to-Device firewall rules block that traffic.

33.1 Remote Management Overview

You may manage your UAG from a remote location via:
• Internet (WAN only)
• LAN only
To disable remote management of a service, deselect Enable in the corresponding service screen.

33.1.1 Remote Management Limitations

Remote management will not work when:
You have disabled that service in the corresponding screen.
1
The accepted IP address in the Service Control table does not match the client IP address. If it
2
does not match, the UAG will disconnect the session immediately.
There is a firewall rule that blocks it.
3

33.1.2 System Timeout

There is a lease timeout for administrators. The UAG automatically logs you out if the management
session remains idle for longer than this timeout period. The management session does not time
out when a statistics screen is polling.
Each user is also forced to log in the UAG for authentication again when the reauthentication time
expires.
UAG CLI Reference Guide
C
HAPTER

System Remote Management

• ALL (LAN&WAN&DMZ)
• DMZ only
3 3
207