Chapter 37 Session Timeout - ZyXEL Communications UAG Series Cli Reference Manual

Use these commands to modify and display the session timeout values. You must use the
configure terminal command before you can use these commands.
Table 141 Session Timeout Commands
COMMAND
session timeout {udp-connect <1..300> | udp-deliver
<1..300> | icmp <1..300>}
session timeout {tcp-established | tcp-synrecv | tcp-
close | tcp-finwait | tcp-synsent | tcp-closewait
tcp-lastack | tcp-timewait} <1..300>
show session timeout {icmp | tcp | udp}
The following example sets the UDP session connect timeout to 10 seconds, the UDP deliver session
timeout to 15 seconds, and the ICMP timeout to 15 seconds.
Router(config)# session timeout udp-connect 10
Router(config)# session timeout udp-deliver 15
Router(config)# session timeout icmp 15
Router(config)# show session timeout udp
UDP session connect timeout: 10 seconds
UDP session deliver timeout: 15 seconds
Router(config)# show session timeout icmp
ICMP session timeout: 15 seconds
UAG CLI Reference Guide
C
HAPTER
Session Timeout
DESCRIPTION
Sets the timeout for UDP sessions to connect or deliver
and for ICMP sessions.
Sets the timeout for TCP sessions in the ESTABLISHED,
SYN_RECV, FIN_WAIT, SYN_SENT, CLOSE_WAIT,
|
LAST_ACK, or TIME_WAIT state.
Displays ICMP, TCP, and UDP session timeouts.
3 7
243