Virtual Interface Specific Commands; Virtual Interface Command Examples - ZyXEL Communications UAG Series Cli Reference Manual

6.3.2.1 Port Grouping Command Examples
The following commands add physical port 5 to interface lan1.
Router# configure terminal
Router(config)# show port-grouping
No. Representative Name
=========================================================
1 wan1
2 wan2
3 lan1
4 lan2
5 dmz
Router(config)# port-grouping lan1
Router(config-port-grouping)# port 5
Router(config-port-grouping)# exit
Router(config)# show port-grouping
No. Representative Name
=========================================================
1 wan1
2 wan2
3 lan1
4 lan2
5 dmz
The following commands set port 1 to use auto-negotiation auto and port 2 to use a 10 Mbps
connection speed and half duplex.
Router(config)# port status Port1
Router(config-port-status)# negotiation auto
Router(config-port-status)# exit
Router(config)# port status Port2
Router(config-port-status)# duplex half
Router(config-port-status)# speed 10
Router(config-port-status)# exit
Router(config)# exit

6.4 Virtual Interface Specific Commands

Virtual interfaces use many of the general interface commands discussed at the beginning of
Section 6.2 on page

6.4.1 Virtual Interface Command Examples

The following commands set up a virtual interface on top of Ethernet interface lan1. The virtual
interface is named lan1:1 with the following parameters: IP 1.2.3.4, subnet 255.255.255.0,
UAG CLI Reference Guide
Port1 Port2 Port3 Port4 Port5
yes no no
no yes no
no no yes
no no no
no no no
Port1 Port2 Port3 Port4 Port5
yes no no
no yes no
no no yes
no no no
no no no
55. There are no additional commands for virtual interfaces.
no no
no no
no no
yes no
no yes
no no
no no
no yes
yes no
no no
Chapter 6 Interfaces
69