Registration Commands; Command Examples - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 5 Registration

5.2 Registration Commands

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 8 Input Values for General Registration Commands
LABEL
user_name
password
The following table describes the commands available for registration. You must use the
configure terminal
commands.
Table 9 Command Summary: Registration
COMMAND
device-register checkuser user_name
device-register username user_name password password
[e-mail user@domainname] [country-code country_code]
[reseller-name name] [reseller-mail email-address]
[reseller-phone phone-number] [vat vat-number]
service-register checkexpire
service-register service-type standard license-key
key_value
service-register service-type trial service content-
filter
show device-register status
show service-register reseller-info
show service-register server-type
show service-register status all
show service-register status content-filter

5.2.1 Command Examples

The following commands allow you to register your device with an existing account or create a new
account and register the device at one time, and activate a trial service subscription.
Router# configure terminal
Router(config)# device-register username alexctsui password 123456
Router(config)# service-register service-type trial service content-filter
48
DESCRIPTION
The user name of your myZyXEL.com account. You must use six to 20 alphanumeric
characters (and the underscore). Spaces are not allowed.
The password for the myZyXEL.com account. You must use six to 20 alphanumeric
characters (and the underscore). Spaces are not allowed.
command to enter the configuration mode before you can use these
DESCRIPTION
Checks if the user name exists in the myZyXEL.com
database.
Registers the device with an existing account or creates a
new account and registers the device at one time.
country_code: see Table 10 on page 49
Gets information of all service subscriptions from
myZyXEL.com and updates the status table.
Activates a standard service subscription with the license
key.
Activates the content filter trial service subscription.
Displays whether the device is registered and account
information.
Displays your seller's information that you have entered
when registration.
Displays the type of the register server to which your
UAG is connected.
Displays all service license information.
Displays content filter service license information.
UAG CLI Reference Guide