Installing a New G700 with an S8300
Administering the LSP Form
If the primary controller has LSPs, you must enter the LSP node names on the LSP form to
enable the LSPs to get translations updates from the primary controller. Once the LSPs are
successfully entered on the LSP screen, their status can be viewed with the display lsp
command.
Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP screen.
To add LSP names to the LSP screen
1. At the S8300 SAT prompt, type change lsp to open the LSP screen.
LSP Screen
change lsp
Number NAME
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2. Enter the node name for each LSP supported by the primary controller and submit the form.
Skip to
Administering the Media Gateway
174 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
LOCAL SURVIVABLE PROCESSOR
IP Address
node-10-LSP_
192.168.1.50
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
Service
State?
in-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
on page 182.
Page
1 of
16
Translations
Updated
14:21 5/4/2003