Display Transceiver Manuinfo - HP 6125XLG Command Reference Manual

Parameters
interface-type interface-number: Specifies an interface by its type and number. If no interface is specified,
this command displays the key parameters of the transceiver modules on all interfaces of the device.
Examples
# Display the key parameters of the transceiver module on interface Ten-GigabitEthernet 1/1/5.
<Sysname> display transceiver interface ten-gigabitethernet 1/1/5
Ten-GigabitEthernet1/1/5 transceiver information:
Transceiver Type
Connector Type
Wavelength(nm)
Transfer Distance(m)
Digital Diagnostic Monitoring : NO
Vendor Name
Table 27 Command output
Field
transceiver information
Transceiver Type
Connector Type
Wavelength(nm)
Transfer Distance(xx)
Digital Diagnostic
Monitoring

display transceiver manuinfo

Use display transceiver manuinfo to display the electronic label data for transceiver modules.
: STACK_SFP_PLUS
: COPPER
: N/A
: 0.65(STACK)
: HP
Description
Transceiver module information.
Transceiver module type.
Connector type options:
•
MPO—Multi-fiber Push On connector.
•
LC—1.25 mm/RJ-45 fiber connector developed by Lucent.
•
RJ-45.
•
Fiber transceiver: Central wavelength (in nm) of the transmit laser. If the
transceiver supports multiple wavelengths, every two wavelength values are
separated by a comma.
•
Copper cable: Displayed as N/A.
Transfer distance, with "xx" representing the distance unit: km (kilometers) for
single-mode transceiver modules and m (meters) for other transceiver modules.
If the transceiver module supports multiple transfer media, the transfer distances are
separated by commas. The transfer medium is included in the bracket following the
transfer distance value. The following are the transfer media:
•
9 um—9/125 um single-mode fiber.
•
50 um—50/125 um multi-mode fiber.
•
62.5 um—62.5/125 um multi-mode fiber.
•
TP—Twisted pair.
•
STACK—RF dedicated cable.
Support for the digital diagnosis function:
•
YES—Supported.
•
NO—Not supported.
165