If a command uses the ID of an existing command, the existing command is replaced.
The system does not check the validity of the command argument. You must make sure the command is
supported by the device, is input in the correct format, and uses valid values. Otherwise, the command
cannot be executed automatically.
Examples
# Assign commands to job backupconfig to back up configuration file startup.cfg to the TFTP server at
192.168.100.1 1.
<Sysname> system-view
[Sysname] scheduler job backupconfig
[Sysname-job-backupconfig] command 2 tftp 192.168.100.11 put flash:/startup.cfg
backup.cfg
Related commands
scheduler job
copyright-info enable
Use copyright-info enable to enable displaying the copyright statement.
Use undo copyright-info enable to disable displaying the copyright statement.
Syntax
copyright-info enable
undo copyright-info enable
Default
The copyright statement is displayed.
Views
System view
Predefined user roles
network-admin
Examples
# Enable displaying the copyright statement.
<Sysname> system-view
[Sysname] copyright-info enable
When a Telnet user logs in, the following statement appears:
•
**************************************************************************
* Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
****************************************************************************
<Sysname>
•
When a console user quits user view, the following message appears:
**************************************************************************
* Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P.
148
*
*
*
*