Tftp-Server Acl - HP 6125XLG Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies the source interface by its type and number. The IPv6
address configured on the source interface is the source address of sent TFTP packets. Make sure the
interface is up. Otherwise, the transmission fails.
ip source-ip-address: Specifies the source IPv6 address of sent TFTP packets. It must be the IPv6 address
of an interface in up state. Otherwise, the transmission fails.
Usages guidelines
If you execute this command multiple times, the most recent configuration takes effect.
The source IPv6 address specified with the tftp ipv6 command takes precedence over the one specified
with the tftp client ipv6 source command.
The source IPv6 address specified with the tftp client ipv6 source command applies to all TFTP
connections while the one specified with the tftp ipv6 command applies only to the current TFTP
connection.
Examples
# Specify source IPv6 address 2000::1 for sent TFTP packets.
<Sysname> system–view
[Sysname] tftp client ipv6 source ipv6 2000::1
Related commands
tftp ipv6

tftp-server acl

Use tftp-server acl to use an ACL to control the device's access to TFTP servers in an IPv4 network.
Use undo tftp-server acl to restore the default.
Syntax
tftp-server acl acl-number
undo tftp-server acl
Default
No ACL is used to control the device's access to TFTP servers.
Views
System view
Predefined user roles
network-admin
Parameters
acl-number: Specifies the number of a basic ACL, in the range of 2000 to 2999.
105