Ssm-Policy (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

Usage gu idelines
CAUTION:
If the device
the source-side DR. When disabling the switchover to SPT, be sure you fully un
network.
In an IPv6 basic ACL, the source keyword matches the multicast group address in IPv6 multicast packets.
If you specify the vpn-instance keyword
parameters except the time-range keyw
Examples
# Disable the switchover to SPT on receiver-side DR on the pu
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] spt-sw

ssm-policy (IPv6 PIM view)

Use ssm-policy to configure the IPv6 SSM group range.
Use undo ssm-policy to restore the default.
Syntax
ssm-policy acl6
undo ssm-policy
Default
The IPv6 SSM group range is FF3x::/32, where x can be any valid scope.
Views
IPv6 PIM view
Predefine d user roles
network-admin
Paramete rs
acl6-number: Specifies an IPv6 basic ACL numbe
Usage guid elines
In an IPv6 basic ACL, the source keyword matches the multicast gro
If you specify the vpn-insta
parameters except the time-range keyw
You can use this command to define an IPv6 multicast group address ra
multicast group is permitted by the
Otherwise, the multicas
Examples
# Configure the IPv6 SSM group range to be FF3E:0:8192::/96.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
is an RP, disabling the switchover to SPT mi
itch-threshold infinity
-number
nce keyword in an ACL rule, the rule does not take effect. The other optional
t mode is IPv6 PIM-SM.
ght cause multicast traffic forwarding failures on
in an ACL rule, the rule does not take effect. The other optional
ord and the fragment keyword in the ACL rules are ignored.
r in the range of 2000 to 2999.
ord and the fragment keyword in the ACL rules are ignored.
used ACL, the multicast mode for the packet is IPv6 PIM-SSM.
341
derstand its impact on your
blic network.
up address in MLD reports.
nge. If a packet to an IPv6