Task
Display MLD information for interfaces.
Display MLD SSM mappings.
Clear dynamic MLD group entries.
MLD configuration examples
Basic MLD features configuration example
Network requirements
As shown in
•
OSPFv3 and IPv6 PIM-DM runs on the network.
•
VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations
form stub networks N1 and N2. Host A and Host C are multicast receiver hosts in N1 and N2,
respectively.
•
MLDv1 runs between Switch A and N1, and between the other two switches (Switch B and
Switch C) and N2.
•
Switch A acts as the MLD querier in N1. Switch B acts as the MLD querier in N2 because it has
a lower IPv6 address.
Configure the switches to meet the following requirements:
•
The hosts in N1 can join only IPv6 multicast group FF1E::101,.
•
The hosts in N2 can join any IPv6 multicast groups.
Figure
91:
Command
display mld [ vpn-instance vpn-instance-name ]
interface [ interface-type interface-number ] [ proxy ]
[ verbose ]
display mld [ vpn-instance vpn-instance-name ]
ssm-mapping ipv6-group-address
reset mld [ vpn-instance vpn-instance-name ] group { all
| interface interface-type interface-number { all |
ipv6-group-address [ prefix-length ] [ ipv6-source-address
[ prefix-length ] ] } }
294