Displaying Mrp Information - Dell PowerConnect B-FCXs Configuration Manual

TABLE 61
This field...
Diag frame sent
Diag frame lost
If the recommended hello time and preforwarding time are different from the actual settings and
you want to change them, refer to

Displaying MRP information

You can display the following MRP information:
•
•
Displaying topology group information
To display topology group information, enter the following command.
Syntax: show topology-group [<group-id>]
Refer to
Displaying ring information
To display ring information, enter the following command.
PowerConnect#show metro
Metro Ring 1
=============
Ring
id
2
Ring interfaces
Interface Type
ethernet 1/1
Regular
ethernet 1/2
RHPs sent
3
Syntax: show metro [<ring-id>]
This display shows the following information.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
CLI display of MRP ring diagnostic information (Continued)
Topology group configuration information
Ring configuration information and statistics
"Displaying topology group information"
State Ring
role
enabled member
Interface role
primary
secondary
RHPs rcvd
0
Displays...
The number of diagnostic RHPs sent for the test.
The number of diagnostic RHPs lost during the test.
"Configuring MRP" on page 349.
on page 336 for more information.
Master Topo
vlan group
2 not conf
Forwarding state
disabled
forwarding
TC RHPs rcvd
0
Metro Ring Protocol (MRP)
Hello Prefwing
time(ms) time(ms)
100 300
Active interface
none
ethernet 2
State changes
4
10
Tunnel
353