Dell PowerConnect B-FCXs Configuration Manual page 260

8
Configuring standard STP parameters
PowerConnect#show process cpu
The system has only been up for 6 seconds.
Process Name
ARP
BGP
GVRP
ICMP
IP
OSPF
RIP
STP
VRRP
To display utilization statistics for a specific number of seconds, enter a command such as the
following.
PowerConnect#show process cpu 2
Statistics for last 1 sec and 80 ms
Process Name
ARP
BGP
GVRP
ICMP
IP
OSPF
RIP
STP
VRRP
When you specify how many seconds' worth of statistics you want to display, the software selects
the sample that most closely matches the number of seconds you specified. In this example,
statistics are requested for the previous two seconds. The closest sample available is actually for
the previous 1 second plus 80 milliseconds.
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this
parameter, the command lists the usage statistics only for the specified number of seconds. If you
do not use this parameter, the command lists the usage statistics for the previous one-second,
one-minute, five-minute, and fifteen-minute intervals.
Displaying the STP state of a port-based VLAN
When you display information for a port-based VLAN, that information includes the STP state of the
VLAN.
To display information for a port-based VLAN, enter a command such as the following at any level of
the CLI. The STP state is shown in bold type in this example.
218
5Sec(%) 1Min(%) 5Min(%)
0.01 0.00
0.00 0.00
0.00 0.00
0.01 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
Sec(%) Time(ms)
0.00 0
0.00 0
0.00 0
0.01 1
0.00 0
0.00 0
0.00 0
0.01 0
0.00 0
15Min(%) Runtime(ms)
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
PowerConnect B-Series FCX Configuration Guide
0
0
0
1
0
0
0
0
0
53-1002266-01