Dell PowerConnect B-FCXs Configuration Manual page 918

26
Displaying IP configuration information and statistics
TABLE 161
This field...
Port
Status
Displaying the static ARP table
To display the static ARP table instead of the ARP cache, enter the following command at any CLI
level.
PowerConnect# show ip static-arp
Static ARP table size: 512, configurable from 512 to 1024
Index
1
3
This example shows two static entries. Note that because you specify an entry index number when
you create the entry, it is possible for the range of index numbers to have gaps, as shown in this
example.
NOTE
The entry number you assign to a static ARP entry is not related to the entry numbers in the ARP
cache.
Syntax: show ip static-arp [ethernet [<slotnum>/]<portnum> | mac-address <xxxx.xxxx.xxxx>
The <slotnum> parameter is required on chassis devices.
The <portnum> parameter lets you restrict the display to entries for a specific port.
The mac-address <xxxx.xxxx.xxxx> parameter lets you restrict the display to entries for a specific
MAC address.
The <mask> parameter lets you specify a mask for the mac-address <xxxx.xxxx.xxxx> parameter, to
display entries for multiple MAC addresses. Specify the MAC address mask as "f"s and "0"s, where
"f"s are significant bits.
The <ip-addr> and <ip-mask> parameters let you restrict the display to entries for a specific IP
address and network mask. Specify the IP address masks in standard decimal mask format (for
example, 255.255.0.0).
NOTE
The <ip-mask> parameter and <mask> parameter perform different operations. The <ip-mask>
parameter specifies the network mask for a specific IP address, whereas the <mask> parameter
provides a filter for displaying multiple MAC addresses that have specific values in common.
The <num> parameter lets you display the table beginning with a specific entry number.
876
CLI display of ARP cache (Continued)
Displays...
The port on which the entry was learned.
NOTE: If the ARP entry type is DHCP, the port number will not be available until the entry gets
resolved through ARP.
The status of the entry, which can be one of the following:
•
Valid – This a valid ARP entry.
•
Pend – The ARP entry is not yet resolved.
IP Address
207.95.6.111
207.95.6.123
[<mask>] |
<ip-addr> [<ip-mask>]] [<num>]
MAC Address Port
0800.093b.d210 1/1
0800.093b.d211 1/1
PowerConnect B-Series FCX Configuration Guide
53-1002266-01