Additional Trunking Options - Dell PowerConnect B-FCXs Configuration Manual

12
Configuring a trunk group
STK1(config)#trunk ethe 1/1/1 ethe 2/1/4 ethe 3/1/7 ethe 4/1/2 ethe 5/1/5 ethe
6/1/7 ethe 7/1/2 ethe 7/1/5
Trunk will be created in next trunk deploy.
STK1(config)#trunk deploy
STK1(config)#show trunk
Configured trunks:
Trunk ID: 1
Hw Trunk ID: 1
Ports_Configured: 8
Primary Port Monitored: Jointly
Ports
Port Names
Port_Status
Monitor
Rx Mirr Port
Tx Mirr Port
Monitor Dir
Operational trunks:
Trunk ID: 1
Hw Trunk ID: 1
Duplex: None
Speed: None
Tag: Yes
Priority: level0
Active Ports: 0
Ports
Link_Status
port_state

Additional trunking options

The following trunking options can be performed on ports in deployed trunks. These options are
supported on static trunk ports. Except where noted, these options are also supported on dynamic
(LACP) trunk ports on PowerConnect B-Series FCX Series devices.
The additional trunking options are as follows:
•
•
•
•
•
•
•
404
1/1/1 2/1/4
none none
enable enable
off off
N/A N/A
N/A N/A
N/A N/A
1/1/1 2/1/4
active active
Forward Forward Forward Forward Forward Forward Forward Forward
Naming a trunk port
Disabling or re-enabling a trunk port
Deleting a static trunk group (applies to static trunks only)
Specifying the minimum number of ports in a trunk group (applies to static trunks only)
Monitoring a trunk port
Configuring outbound rate shaping on a trunk port
Enabling sFlow forwarding on an individual port in a trunk
3/1/7 4/1/2 5/1/5
none none none
enable enable enable
off off off
N/A N/A N/A
N/A N/A N/A
N/A N/A N/A
3/1/7 4/1/2 5/1/5
active active active
PowerConnect B-Series FCX Configuration Guide
6/1/7 7/1/2 7/1/5
none none none
enable enable enable
off off off
N/A N/A N/A
N/A N/A N/A
N/A N/A N/A
6/1/7 7/1/2 7/1/5
active active active
53-1002266-01